Advertisement
Ceramic Cartridge Adjustment
Do not remove the ceramic cartridge from the body assembly while carrying
out the following adjustments. Note, the cartridge is factory set for maximum temperature.
Remove half-dome
(if attached)
Mix temperature limiting adjustment
-
+
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
Australia
USA
UK
Issue B
AMIO SHOWER MIXER WITH DIVERTOR
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min
kPa, Max
kPa.
Recommended installation of a pressure limiting
valve if supply exceeds 500 kPa.
Operating Temperature:
Hot: Min °C (at mixer), Max
°C.
Cold: Min
.
NB: New Zealand Building Code Clause
-
Water Supplies specifies all outlets used
primarily for personal hygiene shall deliver
water at a safe temperature
Inlet Connections:
All ½" BSP.
Advertisement
Table of Contents
Related Manuals for METHVEN Amio Shower Mixer With Divertor
Summary of Contents for METHVEN Amio Shower Mixer With Divertor
- Page 1 All ½" BSP. Mix temperature limiting adjustment Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet. For your warranty please refer to www.methven.com or call Customer Service...
- Page 2 IMPORTANT Please read all of the instructions before installation Avoid restrictive piping, fitting or sharp angled bends when plumbing the mixer. The maximum working pressure of the ceramic cartridge is 1000kPa. Do not hydrostatic test the installation with this mixer installed. Damage to the ceramic cartridge may occur. Distance from All pipework must be thoroughly flushed prior to installation of the mixer.
Need help?
Do you have a question about the Amio Shower Mixer With Divertor and is the answer not in the manual?
Questions and answers