METHVEN Amio Shower Mixer Installation Manual

METHVEN Amio Shower Mixer Installation Manual

Advertisement

Quick Links

Ceramic Cartridge
Adjustment
Note: The cartridge is factory set for maximum temperature.
Do not remove the ceramic cartridge from the body while carrying out the following adjustments.
Remove half-dome (if attached)

Care and Cleaning:

Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
Mix
+
-
temperature
limiting
adjustment
Australia
Amio Shower Mixer
Technical Specifications:
Operating Pressure:
Min:
kPa/
bar
Max:
kPa/ bar*
Operating Temperature:
Hot: Max
°C*
Cold: Min °C
Inlet Connections:
All ½" BSP
USE PARALLEL FITTINGS ONLY
* Regional specific regulations apply.
Please refer to your warranty statement
at www.methven.com
UK
ISSUE B
www.methven.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Amio Shower Mixer and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for METHVEN Amio Shower Mixer

  • Page 1 Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with contamination free warm soapy water and a damp soft cloth. Methven warrants this product against manufacturing defects and that it is suitable for use under the general operating conditions specified in this instruction sheet. However, regional regulations apply and may affect your warranty.
  • Page 2 IMPORTANT: Please read all of the instructions before installation. IMPORTANT: Before you begin, turn off the water supply. General: Installation: • Methven recommends this product is installed by a licensed plumber in compliance with Step 1 all relevant regional regulations. • Remove plastic template, but do not discard.

Table of Contents