Skoda TMB PS 010.01 Installation Instructions Manual page 15

Attachment of the electric cable harness
1. Remote the plug from the hole in the rear wall of vehicle body where the cable
harness passes from the coupling device into the luggage compartment.
2. Slip a new rubber plug on the socket end of that cable harness, lead that harness
in direction from the coupling device into the vehicle and press that plug into
that hole again.
3. Divide the cable harness inside the vehicle so that the thinner part of it leads to
the right rear lamp and the thicker part to the left one.
4. Loosen the grounding nut under the left rear lamp and tighten there the cable
eye with the brown wire.
5. Lead the cable harness inside the coupling crossbeam and fix it in the luggage
compartment with cable clips to the original harness.
6. Disconnect the existing harnesses from the lamps and connect them with the
harness of the coupling device to the lamps. Confusion of the connectors is
impossible.
7. Connect the separate wires of the coupling device harness to the socket
terminals in accordance with the given instructions.
8. Press the rubber plug surrounding the harness into thecutout in the socket and
mount the socket onto the folding holder
15