Skoda TMB PS 010.01 Installation Instructions Manual page 14

Remind:
1. The electroinstallation is delivered in separate packing and is to be ordered
separately depending on selected type under the ordering numbers stated be low:
a) 7-pole socket without the fog lamp switch 12V
b) 7-pole socket with the fog lamp switch 12V
c) 13-pole socket with the fog lamp switch 12V
2. In case of mounting the coupling device directly in the assembly plant or in a
mark service the check of completeness will be done by the customer at
reception of his car.
Instructions for mounting the coupling device on a
vehicle
1. Loosen 5 bolts from the central trim covering the cavity for rear transversal
cable harness in the vehicle luggage compartment and to tear off the plastic
clips on the packing of the rear grouped lamps.
2. Loosen 5 bolts on the lower plastic covering of the rear bumper and dismount
1+1 clips or bolts on both side ends of the bumper near the mudguards.
3. Loosen 2+2 bolts M6 on both inner sides of the vehicle luggage compartment
4. Loosen 1+1 bolts M6 inside the vehicle luggage compartment near the rear
grouped lamps.
5. Remove the rear bumper by towing it rearwards.
6. Make 2 cut-outs for towarm clamp and socket holder in the soft outside
according to the pre-moulded edge inside the lower side of the plastic bumper
covering.
7. Dismount the reinforcement of the rear bumper (2x2 bolts)..
8. From below the vehicle, tear down the selfbonding bands from the connecting
holes in its rear sidemembers.
9. Slide the complete crossbeam with its side flanges into those sidemembers of
the vehicle and fasten it with 2+2 bolts M10, tightening torque 70 Nm.
10. Carry out the assembling of the electric equipment according to the separate
manual.
11. Carry out the remounting of the rear bumper and try to prove the fastening of
the towbar. After its insertion also there must remain a gap approximately 3 - 5
mm between the control lever and the edge of the cutout in the rear bumper.
Otherwise the cutout must be improved.
12. After finishing the assembly of the electric equipment, remounting of the
plastic covering in the luggage compartment can follow.
13. Self-sealing sticker the "75 kg" self-adhesive sticker onto the rear bumper
above the cut-out for the tow arm (the rear bumber should be well degreased in
a place where the sticker is to be placed).
14
EEA 092 038 EL
EEA 092 039 EL
EEA 092 040 EL