6.3
Opening the burner
Disconnect the electrical supply from the bur-
ner.
DANGER
In order to open the burner, proceed as follows:
loosen the 4 screws 1) (Fig. 37) and remove the hood 2);
install the 2 extensions 9) on the guides 4) and re-screw the
screws 8)(only for long head version);
6.4
Closing the burner
In order to close the burner, re-install all components with re-
verse procedure:
remove the 2 extensions 9) and re-screw the screws 8) on the
guides 4) ;
push the burner up to approximately 4" from the pipe cou-
pling;
Maintenance
remove the screws 3) and pull back the burner on the guides
disconnect the electrode lead, then unthread the burner com-
remove the screw 6) and extract the inner part 5) of the head.
reinsert the electrode lead and slide the burner as far as the
fix the screws 3) to secure the burner to the combustion head;
fix the 4 screws 1) to install the hood 2).
Connect the electrical supply from the burner.
4
9
8
2
D9281
31
4) of about 4";
pletely from the guides;
stop.
6
3
7
1
5
1
Fig. 37
20017786