Table of Contents
Advertisement
4
Installation
4.1
Notes on safety for the installation
After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
4.2
Handling
The packaging of the burner includes a wooden platform, so it is
possible to move the burner (still packaged) with a transpallet
truck or fork lift truck.
With regard to the transport in the obligatory passages, refer to
the overall dimensions shown in Fig. 2.
The handling operations for the burner can be
highly dangerous if not carried out with the great-
est attention: keep any unauthorised people at a
distance; check the integrity and suitableness of
WARNING
the available means of handling.
4.3
Preliminary checks
Checking the consignment
After removing all the packaging, check the integ-
rity of the contents. In the event of doubt, do not
use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must
not be abandoned as they are potential sources
of danger and pollution; they should be collected
and disposed of in the appropriate places.
4.4
Operation position
The burner is designed to operate only in the positions 1, 2, 3
and 4 (Fig. 9).
Installation 1 is preferable, as it is the only one that allows the
maintenance operations as described in this manual. Installa-
tions 2, 3 and 4 permit operation but make maintenance and in-
spection of the combustion head more difficult.
Any other position could compromise the correct operation of
the appliance.
Installation 5 is prohibited for safety reasons.
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manu-
al and in compliance with the standards and reg-
ulations of the laws in force.
WARNING
Check also that the area in which you are working is empty and
that there is an adequate escape area (i.e. a free, safe area to
which you can quickly move if the burner should fall).
During the handling, keep the load at not more 10" from the
ground.
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation opera-
CAUTION
tions, carefully clean all around the area where
the burner will be installed.
The output of the burner must be within the boil-
er's firing rate;
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
makes any installation or maintenance work diffi-
WARNING
cult.
1
D7739
17
2
3
4
5
Fig. 9
20017786
Hide quick links:
Advertisement
Table of Contents
