Table of Contents
Advertisement
Using
the ice cube trays
(RTlIDK,
RT14GD
and RT14HK)
If cubes are not used, they may shrink. The
moving cokf air starts a slow evaporation.
The longer cubes are stored, the smaller
they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using
the automatic
ice maker
(Optional
on RT14DK,
RTl4GD
and RT14HK,
factory-installed
on RT14DM)
If you have an automatic ice maker, or if you
plan to add one later (Part No. IMKIT), here
are a few things you will want to know:
l
For models RT14DK, RT14GD and
RT14HK: The aluminum water inlet tube,
supplied with your refrigerator, is in the
bottom rear of the refrigerator, on the
compressor support plate. Use this tube
instead of the tube provided in the acces-
sory kit.
,
l
The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically
UP to shut off the ice maker
IMPORTANT: Do not turn on the ice
maker until it is connected to the water
supply. Instructions
for ke maker water
supply hook up are attached to the
back of the refrigerator cabinet.
l
The dial or lever on the side of the ice
maker changes the size of the cubes.
l
You may hear water running when the ice
maker is working. You'll hear ice falling
into the bin. Don't let these sounds bother
you.
l
If you remove the ice bin, raise the signal
arm to shut off the ice maker. When you
replace the bin, push it in all the way and
lower the ice maker signal arm to the ON
position.
LIP to
stop
he
maker.
[IOWN
to
start
ii::e
maker.
l
Good water quality is important for good
it23
quality. Try to avoid connecting the ice
maker to a soflened water supply. Water
s( bftener chemicals (such as salt from a
malfunctioning softener) can damage the
icl3 maker mold and lead to poor ice
q1 lality. lf a softened water supply cannot
bc! avoided, make sure the water softener
is operating properly and well maintained.
9
Advertisement
Table of Contents
