Pro-Lift F-2332A Operating Instructions & Parts Manual page 4

PREPARATION
Before Use
1. Verify that the product and the application are compatible, if any doubt call Customer
Support @ (816) 891-6390.
2. Before using this product, read the owner's manual completely and familiarize
yourself thoroughly with the product, its components and recognize the hazards
associated with its use.
3. To familiarize yourself with basic operation, use the stamped end of the provided
handle to engage and turn the release valve:
a. Clockwise until firm resistance is felt to further thread engagement. This is the
'CLOSED' release valve position used to raise the load.
b. Counter-clockwise, but no more than 1/2 full turn from the closed position.
This is the 'OPEN' release valve position used to lower the load.
4. With saddle fully lowered, locate and remove the cover plate, then remove the oil
filler plug. Insert the handle into the handle sleeve; then pump 6 to 8 full strokes.
This will help release any pressurized air which may be trapped within the reservoir.
Check oil level. Proper oil level will vary from just covering the ram cylinder to 3/16"
above it as seen from the oil filler plug hole. Reinstall the oil filler plug.
5. Check to ensure that jack rolls freely (if so equipped) and that the pump operates
smoothly before putting into service. Replace worn or damaged parts and assemblies
with factory Authorized Replacement Parts only. Contact the manufacturer or
distributor of this product for a list of factory authorized service centers (see page 7,
Replacement Parts List). Lubricate as instructed in Maintenance Section.
Bleeding / Venting Trapped Air
With the release valve in the OPEN position (3b above) and with saddle fully lowered,
locate and remove the oil filler plug. Insert the handle into the handle sleeve; then
pump 6 to 8 full strokes. This will help release any pressurized air which may be
trapped within the reservoir. Oil level should be even with the bottom of the oil filler
plug hole. Reinstall the oil filler plug.
OPERATING INSTRUCTIONS
!
This is the safety alert symbol. It is used to alert you to potential personal
injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
Lifting
1. Place vehicle in park, with emergency brake on and wheels securely chocked to
prevent inadvertent vehicle movement.
2. Locate and close release valve by turning handle clockwise until firm resistance is felt
to further thread engagement. Center jack saddle under lift point.
3. Insert handle into handle sleeve and pump to contact lift point. Verify the lift point,
then pump the handle until load reaches desired height.
4. Transfer the load immediately to a pair of appropriately rated jack stands.
!
Use only the handle assembly provided by the jack manufacturer. The
handle assembly provided with this jack will safely engage the release valve
and operate the handle sleeve. If the handle is worn, operates abnormally, or will
not positively engage the release valve, STOP, discontinue use of the jack until a
factory replacement handle assembly can be acquired.
4