Saab R5 SOLID Installation Short Instruction page 2

R5 SOLID Installation Short Instruction
SYSTEM CONFIGURATION
NOTE: Set correct System mode (CLASS A /
Set up the following parameters under: Main Menu
Class A Mode
MMSI MMSI
IMO IMO = 0
Call Sign ATIS CODE
Ship Name Ship Name
Height over Keel Height over Keel
Ship Type ERI Code / Euro type
Ship Dimension* SOG/COG/HDG quality
- Euro number
Ship and Convoy total Dimensions*
*SET SHIP DIMENSIONS
There are two methods for setting Ship Dimensions. The configuration
parameter "Ship Size Mode" in the Misc Interfaces view, shall be set to
Standard Mode or Simplified Mode (default).
If external ECDIS will be used for full AIS configuration, Standard Mode is
recommended unless the ECDIS integration has been verified with R5.
CLASS A Standard Mode
In this mode data is entered exactly as is will be reported on VHF link.
Input:

A, B, C, D for internal antenna [m]

A, B, C, D for external antenna [m]
Inland Standard mode:
A,B,C,D above shall be entered and shall reflect the vessel plus any extra
convoys attached. Also set:

Convoy/ship total length x.x [m] (one decimal precision)

Convoy/ship total beam x.x [m] (one decimal precision)
NOTE: Make sure A+B = Convoy/ship length rounded up, C+D =
Convoy/ship beam rounded up. Failure to set this correctly will cause the
"Ship size mismatch" alarm to be activated.
Inland before proceeding)
 
Config Ship Static
Inland Mode
Class A Simplified Mode (default)
In Simplified mode the transponder will automatically calculate and
correctly round the A,B,C and D values reported on the VHF link from
Length, Beam, X and Y.
Input:

Ship length x.x [m] (one decimal precision)

Ship beam x.x [m] (one decimal precision)

X, Y for internal antenna relative to ship x.x [m] (one decimal
precision)

X, Y for external antenna relative to ship x.x [m] (one
decimal precision)
Inland Simplified Mode:
Set Length, Beam, X and Y parameters as above.
Specify any extra convoy size in Main Menu
Extra convoy size on each side (value = 0 if convoy not used):

Bow x.x [m] (one decimal precision)

Stern x.x [m] (one decimal precision)

Port side x.x [m] (one decimal precision)

Starboard x.x [m] (one decimal precision)
A,B,C and D values reported on the VHF link will be calculated from
Length, Beam, X,Y and any extra convoy sizes.
This mode will make it easier for Inland AIS users to quickly change all
relevant dimensions when changing convoy configuration, but may cause
problems for external ECDIS integrations.
7000 118-201 A3
 
Voyage Convoy Settings.