Dahua DH-PFS4218-16GT-190 Quick Start Manual page 18

Configuration Steps
To configure the switch, do the following:
Step 1 Create the VLAN.
SWITCH #configure terminal
SWITCH (config)#vlan 2
SWITCH (config-vlan)# exit
SWITCH (config)#vlan 3
SWITCH (config-vlan)# exit
Step 2 Allocate the ports into the VLAN.
SWITCH(config)# interface GigabitEthernet 1/1
SWITCH (config-if)# switchport access vlan 2
SWITCH (config-if)# exit
SWITCH (config)# interface GigabitEthernet 1/2
SWITCH (config-if)# switchport access vlan 3
SWITCH (config-if)# exit
Figure 4-2 VLAN networking
Quick Operation 12