Page 1
309 271 01 LUNA LUNA 111 top2 LUNA 112 top2 Dat a Dat a – Ext1 Ext2 – 111 0 100, 111 0 200 112 0 100, 112 0 200 Assembly and operating instructions MENU MENU Digital twilight switch 0,5mm -...
Contents Basic safety instructions Screen and keys/operating instructions Overview of menu selection Connection/installation Connection/installation of light sensor Initial start-up Menu item LIGHT Set lux values/delay Menu item MANUAL Manual and permanent switching Menu item OPTIONS Enter PIN code Allocate sensors External output OBELISK top2 memory card Technical data...
Basic safety instructions WARNING Danger of death through electric shock or fire! Installation should only be carried out by professional electrician! • The device corresponds to EN 60669-2-1; it is designed for installation on DIN top hat rails (in accordance with EN 50022) and for use in normal environment Designated use •...
Screen and keys Operating instructions 1. Read text line Sunrise/sunset display Flashing text/symbol Text line messwert represents query Lux value display Channel status C1, C2 2. Make a decision Display of active keys with relevant function bbbb confirmation Revise/ MENU change –...
Overview of menu selection MENU READING LIGHT MANUAL OPTIONS CHANNEL C1 CHANNEL C1 SENSORS OPERATING LUX VALUES PERMANENT HOURS METER EXTERNAL DELAY OUTPUT PERMANENT LCD ILLUMI- NATION MANUAL ON LANGUAGE TIMER FACTORY SETTING INFO * only with LUNA 112 top2...
Connection/installation WARNING Warning, danger of death through electric shock! Must be installed by professional electrician! 45° cable Connect power source. Cover or shield any adjacent live compo- Spring screwless nents. terminal Ensure device cannot be switched on! Check power supply is disconnected! Spring screw- Earth and bypass! less terminal...
Connection/installation of light sensor Take length of connection cable into account: max. 100 m (2 x 1.5 mm ), max. 50 m (2 x 0.75 mm Avoid running sensor wiring parallel to mains power cables. Connect power source. Ensure correct polarity. Mounting light sensor: 0.5-2.5 mm , strip cable by 10 mm (max.
Initial start-up Set language, channel and measured value The device is preset at 15 lx for switch on/switch off GERMAN CHANNEL level. READING Press required key and display follows on screen (see picture). If all settings are performed, the screen alternately shows the auto- Typical brightness values matic display and READING.
Set lux values LIGHT Press MENU (see picture). CHANNEL LUX VAL- LUX ON DELAY LUX OFF Set delay Press MENU (see picture). An on/off delay of 1 minute is preset to DELAY ON DELAY avoid faulty operation caused by lightning, car headlights etc.
OPTIONS (see picture). Manual and permanent switching can be set If you have forgotten the PIN please call using the menu in MANUAL or (in the auto- the Theben Hotline. matic screen) by key combination (see picture). OPTIONS SENSORS Channel...
Allocate sensors The SENSORS are allocated in the menu OPTIONS under OPTIONS. SENSORS CHANNEL Press MENU (see picture). OPERATING 1 SENSOR HOURS METER RECOGNISED SENSOR EXTERNAL 1 ACTIVE OUTPUT SENSOR Connection options: LCD ILLUMI- SENSOR 1 NATION red LED flashes 1 LUNA + 4 light sensors on the sensor LANGUAGE...
External output The EXTERNAL OUTPUT is set via the menu in OPTIONS (see picture). OPTIONS SENSORS OPERATING HOURS METER EXTERNAL CHANNEL OUTPUT LCD ILLUMI- MINUTES STAIRCASE SECONDARY NATION SWITCHING LIGHT LAN- SWITCH MANUAL CAN BE SHUTDOWN GUAGE TIMER INACTIVE * Use key without glow lamp.