Install Properly; Level Refrigerator-Freezer; Removesaleslabels; Clean It - Whirlpool ETl4EP Use And Care Manual

Install properly..
1. Allow 3 inches (7.5 cm] between overhead cabi-
nets and refrigerator top.
2. Allow at least an inch (2.5 cm) between the
refrigerator condenser on the back and the wall.
3. Allow % inch (1.25 cm] on each side of the
refrigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
' :t-- ,
i8fi , .: -3wswmm ? 411 L 3
Level refrigerator-freezer.. .
1. Adjust each leg until the refrigerator won't rock.
2. Slide the refrigerator into place.
3. Adjust front legs to level the refrigerator.
- To raise corners, turn legs clockwise.
- To lower corners, turn legs counterclockwise,
4. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
lnslde
labels before using the refrigerator.
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlortde, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the retrigemtor at the front.
~' 'I. es' 'C
/ j. .Il,lT.r .I.>. j ,l. _' 1
Clean it...
Clean your refrigerator
before using it.
See cleaning instructions
on page 8.
j-prong grounding
type wall receptacle,
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off wlth a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.