Table of Contents
Advertisement
Changing the light bulb...
WARNING: Before removing
the light shield for
cleaning
or for replacing
the bulb,
elther unplug retrlgerutor
or dlscon-
nect
electrlclty
leading
to re-
frigerator
at the maln power supply.
Shock and InJury can occur if elec-
triclty remalns connected.
Push in the Center;
Pull Down.
1. Push lightly on the top center of the light shield uniil
the notched
tab unhooks from the control panel.
2. Pull down on the shield until the tab clears the con-
trol panel.
3. Lift the back hooks out of their slots
4. Replace
with a 40.watt appliance
bulb.
5. Replace
light shield in reverse order
Optional automatic ice maker.. .
If you have the automatic
ice maker accessory
or
plan to add one later (Part No. ECKMF-83). there are a
few things you will want to know:
l
The ON/OFF
lever is a wire signal arm.
Down.. .for making
ice automatically;
Up...to shut off the ice maker.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain
increased
storage capacity.
l
It is nmmal for ice crescents to be attached
by a
corner. They will break apart easily.
On
Lnurar
Ci
P Lrrn to Start It.
Raise Signal
-Arm
to Stop Ice Maker.
l
You will hear water
running
when ice maker
is
working.
You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The ice maker will not operate
until the freezer is
cold enough to make ice. This can take overnight.
l
Because
of new plumbing
connections,
the first
ice may be discolored
or off-flavored.
Discard the
first few batches
of ice.
l
If ice is not being made fasi enough and more ice
is needed,
turn the Temperature
Control toward a
higher number. Wait a day and, if necessary,
turn
the Air Control toward A.
l
If you remove the ice bin, raise the signal arm tc
shut off the ice maker. When you return the bin.
push it all the way in and lower the arm to the Oh
position.
l
If cubes are stored too long, they may develop
an
off-flavor...like
stale water. Throw them away. They
will be replaced.
Cubes
in the ice bin can alsc
become
smaller by evaporation.
l
Good water quality is important forgood
ice quality.
It is not recommended
that the ice maker be con-
nected
to a softened
water supply Water softener
chemicals
such as salt from a malfunctioning
soft-
ener can damage
the ice maker mold and lead to
poor quality ice. If a softened water supply cannot
be avoided,
then it is important
that the water soft-
ener be well maintained
and operating
properly.
Removing the base grille...
1. Open the doors,
I II
2. Pull grille outwards as shown.
3.
Do not removeTech sheet
fastened behind grille.
To replace:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
Advertisement
Table of Contents
