Table of Contents
Advertisement
2 Engineering
Installing the software (download)
This chapter describes the steps for installing the sample code.
1. Install TIA Portal V14 SP1 or higher.
2. The Step 7 V14 SP1 project is available on the HTML page from which you
downloaded this document (\2\). Save the
"109757269_SIMATIC_MV440_ASM456_S7-xxx_TO.zip" project (depending
on the CPU) to your hard drive.
3. Unzip the file.
4. In TIA Portal, open the project you have just unzipped:
"Project" > "Open" > "Browse".
5. The project is now available to you.
Startup
This chapter describes the steps for starting up the sample code.
1. Wire your hardware.
2. Open the application example in TIA Portal.
3. If you are using alternative hardware, perform the configurations described in
chapter
4. Assign an IP address from the IP range of the configured S7 CPU of the
application example to your programmer or customize the IP address of the
CPU to your preferences.
5. Download the user program to your S7 CPU. To do this, select the S7 CPU in
your project tree (1) and then click "Download to device" (2).
Figure 2-11
MV Basics
Entry ID: 109757269,
V1.0,
"2.8
Configuration".
04/2018
29
Advertisement
Table of Contents
