Siemens SINAMICS G120P Manual page 11

2 Engineering
Operating parameters and motor data identification
After setting the motor parameters, you can set some parameters that influence the
operating behavior of the drive.
Table 2-5: Configuration
Step
1.
2.
3.
The acceleration and deceleration time is entered in seconds and refers to the
maximum speed of the motor (p1082). The extended acceleration and deceleration
behavior of the drive protects the mechanics.
Figure 2-4: Ramp-up and ramp-down time
Speed
p1082
p1001
After setting parameter p1900, the display of the BOP-2 shows "FINISH". Now
complete the quick commissioning.
Table 2-6: End of commissioning
Step
1.
2.
Pump with SINAMICS G120P
Entry-ID: 109759888, V1.0.1,
Parameters
p1120 Parameters p1120 (acceleration time) and p1121
p1121 (deceleration time) allow you to influence the acceleration
and deceleration behavior of the drive.
p1082 If you require a speed >1500 1/min, increase the parameter
p1082 (maximum speed) accordingly.
p1900 The default setting for motor data identification is p1900 = 2.
If drive releases are present, motor data identification is
carried out at standstill with the next switch-on command.
The motor carries current and can align up to a quarter turn.
The setting p1900 = 0 locks the motor data identification.
p1120
Use an arrow key to change the display: nO → YES
Press the OK button.
09/2019
Description
Time
p1121
Description
11