Table of Contents
Advertisement
5
5
Connect the Live Wire with the Terminal as shown.
如圖所示連接火線與端子。
6
6
To close the Speed Regulator, insert the two holes on top of the Speed
Regulator to the two protruding parts at the base.
Finally, screw them together.
將調速器頂部的兩個孔插入底部的兩個突出部分以關閉調速器。
最後，以螺絲將它們鎖緊。
Final Confi rmation / 最後確認
H)
1
1
Measure the distance using a measuring tape.
Please adjust all the Blades to get the equal distance from ceiling to the Blade Tip, L (within 1 mm tolerance).
使用捲尺測量距離。
請調整所有扇翼，使天花板至扇翼末端L的距離相等（1 毫米公差之）。
After installation make sure the Ceiling Fan does not wobble
extremely.
Can cause injury if Ceiling Fan drops.
安裝后，請確定吊扇不會過度搖晃。
若吊扇掉落會導致受傷。
Hold the Motor Assembly by hand and adjust the Blade carefully untill the height (L) differences is ±1 mm.
用手握住發動機組件，然後小心調整扇翼直至高度（L）的差異為±1 毫米。
CAUTION / 注意
Pitching Method / 校準方法
Live Wire / 火線
L
1
Holes / 孔
Hold by hand /
用手握住
Push up or press down carefully /
謹慎地推上或者按下
15
Protruding parts /
凸出部分
Screw /
螺絲
L
Advertisement
Table of Contents
