Table of Contents
Advertisement
Quick Links
MICRO SD CARD
ETHERNET PORT
SERIAL PORT
BACKLIT DISPLAY
CAN / DEVICENET SLAVE /
USER PROGRAMMABLE
(5 WAY CONNECTOR)
16 PNP OR NPN INPUTS
INC 8 REGISTRATION
(I-O CONNECTOR 1)
QUICK START GUIDE
T E C H N O L O G Y
8 DIGITAL OUTPUTS
(I-O CONNECTOR 2)
8 DIGITAL OUTPUTS
(I-O CONNECTOR 3)
ALALOGUE IN
DIGITALOUT / WDOG
(I-O CONNECTOR 4)
8 MDR FLEXIBLE AXIS
MC508
P848 | P849
CHASSIS
EARTH SCREW
PANEL OR
DIN MOUNT
Advertisement
Table of Contents
Related Manuals for Trio MC508 P848
Summary of Contents for Trio MC508 P848
- Page 1 T E C H N O L O G Y MICRO SD CARD ETHERNET PORT 8 DIGITAL OUTPUTS SERIAL PORT (I-O CONNECTOR 2) BACKLIT DISPLAY 8 DIGITAL OUTPUTS CAN / DEVICENET SLAVE / (I-O CONNECTOR 3) USER PROGRAMMABLE ALALOGUE IN (5 WAY CONNECTOR) CHASSIS DIGITALOUT / WDOG...
-
Page 2: Safety Warning
Safety Warning During the installation or use of control systems, users of Trio products must ensure that there is no possibility of injury to any person or damage to machinery. Control systems, especially during installation, can malfunction or behave unexpectedly. Bearing this in mind, users must ensure that even in the event of a malfunction or unexpected behaviour, the safety of an operator or programmer is never compromised. - Page 3 i/o ConneCtor 1 PNP (current sink) operation: Connect common to 0V. NPN (current source) operation: Connect common to 24V. Any input, 0 - 7, may be mapped to any axis as a registration input. Input Optical Input Signal Common i/o ConneCtor 2 PNP operation: Connect common to 0V.
-
Page 4: Amplifier Enable (Watchdog) Relay Output
See MC4 range technical manuals for details. Trio Controller Servo Amplifier En- able or Safety Relay all Stepper and SerVo aMplifierS MUSt be inhibited When the aMplifier enable oUtpUt iS open CirCUit. - Page 5 flexible axiS ConneCtor Pulse & Absolute Incremental Pulse & Direction Direction Encoder Encoder Function Function Function Function (P849 ONLY) Enc A(n) Pulse(n) Pulse(n) Clock(n) Enc /A(n) /Pulse(n) /Pulse(n) /Clock(n) Enc B(n) Dir(n) Dir(n) Enco /B(n) /Dir(n) /Dir(n) +5V Enc (100mA max.) Do not connect WDOG(n)+ WDOG(n)-...
-
Page 6: Lcd Display
lCd diSplay The IP address and subnet mask of the MC508 is shown on the LCD display for a few seconds after power-up. The factory default IP address is 192.168.0.250. This can be changed using the ETHERNET or the IP _ ADDRESS command via Motion Perfect. ENABLE Display at start-up Display with WDOG on... - Page 7 ChaSSiS MoUnting diMenSionS (looking froM front) M4 screws should be used in 3 places to mount the MC508 to an unpainted metal panel. The best EMC performance is obtained when the MC508 is attached from the shield screw (marked) using a flat braided conductor with a cross section of 4mm x 1mm.
- Page 8 M O T I O N S P E C I A L I S T CAD data Drawings to aid packaging and mounting are available in various formats from the Trio web site. Products should be wired by qualified persons.