Crown Boiler BWF Series Installation Instructions Manual page 38

11. Operation (continued)
Press I to enter OPERATING MODE
    =Call for Heat? (On/Off)
    =Call for DHW? (On/Off)
N
(Visible when Lockout is Present)
      = Code for Error Present (Table 13.0)
 Except as shown above, press I to navigate through menu.
 Use ↑,↓ to change parameters in Adjustment Mode
38
Figure 11.2: Boiler Control Menu
      =Current Status (Table 11.3)
    = Current Boiler Temp.
    = Current Set Point
    = High Limit Setting
      = Limit Differential
      =Flame Signal (uA)
      =Total Run Time (hrs)
      =total burner Cycles
Boiler in
Lockout?
Y
ERROR MODE
STATUS MODE:
Press and Hold I, ↑, and ↓ for at least 3
sec to enter ADJUSTMENT MODE
    = High Limit Setting
      = Limit Differential
    =Circulator Overrun
    =Thermal Purge Time
    =Thermal Purge Temp
    =DHW Priority (ON/OFF)
    =Use of 2
      =Temperature Units
      =Return to Status Mode
Press I
Y
nd Zone
      =Reset
Press ↑ or ↓
N
Boiler in
Lockout?
109836-01 - 04/20