Imperial DABMAN i500 BT Manual page 89

After successful installation, the system restarts. If you don't want to do this manually
every time, please select „Automatic updates".
If you prefer to get involved from time to time, click on „Check for updates".
CAUTION:
When a firmware update is made, all settings you have made will be lost
(e.g. network profiles, favourite stations, equaliser settings). These must therefore
be remade after the update.
Would you like to start again from scratch and reset the date and network connections?
Then just start the setup wizard again!
E
Menu interval
Here you can set the length of time that the device will wait before changing from the list
view back to the playback view.
Device info
All information relevant to the device is displayed in this menu. Here you will find the ins-
talled firmware version and the hardware ID of your DABMAN i500 BT. The information
found here is also very helpful if you require support from us. Then use the Back button
to get back to the settings.
Backlight timeout (sec)
Here you can choose when the illumination of the colour display switches off automati-
cally. You can either turn off the automatic setting so it is always [On] or choose a timeout
of between 10 and 180 seconds.
Operating status
Here you can select how bright the display should be during operation.
You can choose between the three levels [High], [Medium] and [Low]. The default is [High]
Standby mode
Here you can choose how bright the display should be in standby mode. You can choose
between the two levels [Medium] and [Low]. The default is [Medium]
89 IMPERIAL DABMAN i500 BT
BDA Dabman i 500_BT_Deutsch_01_19.indd 89 18.02.19 13:13