Table of Contents
Advertisement
6
Chapter
6.1. Camcorder Settings
Because of some system restrictions, "Live Streaming" is not available in the following cases. Check the
camcorder settings.
– When System > Rec Format > Codec is set to DVCAM(MXF) in the setup menu
– When Recording > S&Q Motion > Setting is set to On in the setup menu
– When Recording > Interval Rec > Setting is set to On in the setup menu
Streaming at up to 10Mbps is supported under the following conditions.
– When Camera > Focus > Face Detection AF is set to Face Only AF or Face Priority AF in the setup menu
– When an intercom headset is connected
6.2. Streaming Test
After checking that Network Client Mode communication is successful, you can check QoS streaming.
This test is controlled from the CCM UI.
1
Select the camcorder and set the Network Range and destination receiver (Network RX Station).
2
Issue the Start command for QoS streaming from the CCM.
The camcorder starts streaming.
When streaming is successful, the
picture appears in the CCM UI preview area.
If you experience any difficulty, see
Setup for "Live Streaming"
icon appears on the camcorder LCD screen and the streaming
"12.3.1. Live Streaming"
in the Troubleshooting section.
33
Hide quick links:
Advertisement
Table of Contents
