Sony PXW-Z280 Setup Manual page 27

Modem1 Modem2
OFF OFF
OFF OFF
OFF OFF
OFF OFF
5.3.4.1. IP address conflicts
IP address conflicts may occur when using multiple network interfaces simultaneously, depending on the
settings. IP addresses within the same segment may overlap, preventing successful communication.
The following table shows the IP address conflict pattern and the operation that results.
No. IF connection (startup) order
1
1 Modem 1
Modem 2
2 AP mode
3 Modem 1
Modem 2
4 Modem 1
Modem 2
5 ST mode
(Auto/Manual)
6 Modem 1
Modem 2
7 Modem 1
Modem 2
8 AP mode
9 Wired LAN
(Auto/Manual)
10 ST mode
(Auto/Manual)
11 Wired LAN
(Auto/Manual)
Wired LAN Wireless LAN
ON ON
ON OFF
OFF ON
OFF OFF
2 3
Modem 2 –
Modem 1
Modem 1 Modem 2
Modem 2 Modem 1
AP mode Modem 2
Modem 1
Modem 2 AP mode
Modem 1
Modem 1 Modem 2
Modem 2 Modem 1
ST mode Modem 2
(Auto/Manual)
Modem 1
Modem 2 ST mode
(Auto/Manual)
Modem 1
Wired LAN –
(Auto/Manual)
AP mode –
Wired LAN –
(Auto/Manual)
ST mode –
(Auto/Manual)
Operation
Dual Link: Uses Wired LAN and Wireless LAN.
Single Link: Uses Wired LAN.
Dual Link cannot be used.
Single Link: Uses Wired LAN.
Dual Link cannot be used.
Single Link: Uses Wireless LAN.
Network function is disabled.
Operation
If the segment IP address ranges overlap between
modems, an address conflict error is displayed.
 If the segment IP address ranges overlap
between the AP and the modem, the AP mode
address is automatically changed to another
segment and an AP mode address change
message is displayed.
 If the second segment IP address ranges overlap
between the AP and the modem, an address
conflict error is displayed.
 If the segment IP address ranges overlap
between modems, an address conflict error is
displayed.
 If the segment IP address ranges overlap
between the AP and the modem, the AP mode
address is automatically changed to another
segment and an AP mode address change
message is displayed.
 If the segment IP address ranges overlap
between modems, an address conflict error is
displayed.
 If there is an IP conflict between the modem and
the ST, an address conflict error will be displayed
and the user will be prompted to change it.
 If the segment IP address ranges overlap
between modems, an address conflict error is
displayed.
 If the IP address of the ST is included in the
modem subnet, an address conflict error is
displayed.
If the segment IP address ranges overlap between
the AP and the wired LAN, the AP mode address is
automatically changed to another segment, and an
AP mode address change message is displayed.
If there is an IP conflict between the wired LAN and
the ST, an address conflict error is displayed and the
user is prompted to change it.
27