Table of Contents
Advertisement
C
5. Locate the collet chuck (F), Evolution hollow revolving centre
(G), Pen mandrel assembly (H), 'C' spanner (I) and push rod (B).
6. Put to hand the ER20 collet chuck nut with the 6-5mm collet
(F) attached. Screw the collet chuck assembly on to the spindle
taper on the head stock, see fig 08.
7. Locate the 'C' Spanner (I) and push rod (B). Insert the push
rod into the pre-drilled hole in the spindle collar, introduce the
'C' spanner (I) over the collet check (F) until the locating pin
engages into one of the elongated holes around the collet
chuck (F). While holding the push rod in place, tighten the
collet chuck, see fig 09-10.
Fig 08-09-10
B
150mm Tool rest
I
Tailstock
barrel
G
8. Locate the evolution revolving live centre (G), insert the
taped end into the barrel shaft on the tailstock until it locks in
place, see fig 12-13-14.
Pen Mandrel
1. Locate the pen mandrel assembly (H), remove the bushings
and mandrel spacers, see fig 15.
Mandrel spacers
Mandrel shaft
7
Assembly
Fig 12-13-14
Tailstock
Bushings
Continues Over....
Fig 15
Advertisement
Table of Contents
