Table of Contents
Advertisement
General Instruction for 230V Machines
Good Working Practices/Safety
The following suggestions will enable you to observe good
working practices, keep yourself and fellow workers safe and
maintain your tools and equipment in good working order.
WARNING!! KEEP TOOLS AND EQUIPMENT OUT
OF THE REACH OF YOUNG CHILDREN
Primary Precautions
These machines are supplied with a moulded 13 Amp. Plug
and 3 core power cable. Before using the machine inspect the
cable and the plug to make sure that neither are damaged. If
any damage is visible, have the tool inspected/repaired by a
suitably qualified person. If it is necessary to replace the plug,
it is preferable to use an 'unbreakable' type that will resist
damage. Only use a 13 Amp plug, and make sure the cable
clamp is tightened securely. Fuse as required. If extension leads
are to be used, carry out the same safety checks on them, and
ensure that they are correctly rated to safely supply the current
that is required for your machine.
Work Place/Environment
Make sure when the machine is placed that it sits firmly on the
bench or stand, that it does not rock, that it is sufficiently clear
of adjacent obstacles so that you have unimpeded access to all
parts of the machine. The machine is designed for indoor use,
do not use when or where it is liable to get wet.
Keep the machine clean; it will enable you to more easily see
any damage that may have occurred.
Clean the overall machine with a damp soapy cloth if needed,
do not use any solvents or cleaners, as these may cause damage
to any plastic parts or to the electrical components.
Clean the machine components with a lightly oiled cloth. If the
machine is liable to be standing idle for any length of time, a
light coat of machine or spray oil will minimise rusting.
KEEP THE WORK AREA AS UNCLUTTERED AS
IS PRACTICAL, THIS INCLUDES PERSONNEL
AS WELL AS MATERIAL.
UNDER NO CIRCUMSTANCES SHOULD
CHILDREN BE ALLOWED IN WORK AREAS.
It is good practice to leave the machine unplugged until work
is about to commence, also make sure to unplug the machine
when it is not in use, or unattended. Always disconnect by
pulling on the plug body and not the cable. Once you are
ready to commence work, remove all tools used in the setting
operations and place safely out of the way. Re-connect the
machine.
Carry out a final "tightness" check e.g. chuck or faceplate,
workpiece, tool rest, etc., check that the correct speed has been
selected.
Make sure you are comfortable before you start work,
balanced, not reaching etc. If the work you are carrying out is
liable to generate flying grit, dust or chips, wear the appropriate
safety clothing, goggles, gloves, masks etc. If the work operation
appears to be excessively noisy, wear ear-defenders. If you wear
your hair in a long style, wearing a cap, safety helmet, hairnet,
even a sweatband, will minimise the possibility of your hair
being caught up in the rotating parts of the tool. Likewise,
consideration should be given to the removal of rings and
wristwatches, if these are liable to be a 'snag' hazard.
Consideration should also be given to non-slip footwear, etc.
DO NOT work with cutting tools of any description if you are
tired, your attention is wandering or you are being subjected to
distraction. A deep cut, a lost fingertip or worse is not worth it!
Above all, OBSERVE.... make sure you know what is happening
around you, and USE YOUR COMMON SENSE.
4
Advertisement
Table of Contents
