Table of Contents
Advertisement
Operating Instructions
Fig 30-31
5. Screw on the collet chuck assembly (F), replace the pen
mandrel assembly (H) and project blank/s as detailed on page 8
and tighten with the push rod (B) and 'C' spanner (I), see fig 32.
Fig 32
B
There are a range of optional accessories for
the Precision Pro Lathe. See page 16-17 for
all available accessories.
Removing the Live Centre from the Tailstock
To remove the live centre (G) from the tailstock, locate the push
rod (B), hold the live centre and insert the push rod through the
centre hole of the tailstock wheel, see fig 33. Remove the live
centre from the tailstock and place safely aside, see fig 34.
Drive Belt Tension
When operating the lathe, if you suddenly notice the drive
spindle stops moving or stops altogether when using your
woodturning tools, it may be that the drive belt has
become slack. If this occurs follow the steps below.
1. Loosen the access panel locking bolt and open the rear
panel, see fig 35-36.
I
2. Check the tension of the drive belt, if adjustment is required
loosen the motor clamping bolt and press down the motor
assembly with moderate pressure then re-tighten clamping
bolt to secure the setting, see fig 37.
14
Fig 33-34
Fig 35-36
Advertisement
Table of Contents
