Table of Contents
Advertisement
Daily After Use
• Clean wood shavings away from the lathe bed and tool rest.
• Smear a light coat of wax, Protec Tool Wax Polish code. 211835' ,
see fig 38 over the lathe bed to allow the banjo and tailstock to
run more smoothly over the bed and to prevent corrosion.
• Remove the collet chuck assembly (F), remove the collet and
clean.
Monthly
• Check the tension of the belt and adjust if required, see
opposite page. Check the condition of the belt for signs of
wear and change if required. For after sales enquires, call
03332 406406.
• Check any build-up of wood shavings on the motor and
spindle pulleys and clean if necessary.
WARNING!! ALWAYS WEAR EYE PROTECTION
WHEN USING AN AIR LINE.
• Using an airline, blow out the motor's air vent (A),see fig 39.
• Also blow out the air vents on the control box (B), see fig 40.
NOTE: IF THE LATHE IS NOT GOING TO BE USED
FOR A PERIOD OF TIME, SMEAR A LIGHT COAT
OF 'PROTEC TOOL WAX POLISH' OVER THE BED
AND PLACE A DUST SHEET OVER THE LATHE.
B
15
Operating Instructions
Maintenance
Fig 38-39-40
Continues Over....
Fig 37
A
Advertisement
Table of Contents
