Table of Contents
Advertisement
1. Do not use 'split' workpieces.
2. Always start at the lowest speed when starting a new task.
3. Check that the tool rest is at or slightly below the centre line
of the workpiece.
4. Check the workpiece is securely mounted in the lathe before
switching on the power.
5. Rotate the workpiece by hand, to check that it is centralised,
clear of the tool rest, not 'split' or has loose knots.
6. Where lathes have the facility to be reversed, check the
machine is rotating in the correct direction.
7. If your lathe has the facility to run in reverse, you must ensure
that the mounting accessories (chucks, faceplates etc.) can be
Code
Model
Rating
Power
Speed
Spindle Type
Spindle Thread
Taper Tailstock
Distance Between Centres
Max Diameter over Bed
Tool Rest Stem Diameter
Overall L x W x H
Weight
Specific Safety Instruction for Woodworking Lathes
5
'locked' onto the lathe mandrel and, in the case of chucks have
some form of security device to prevent them 'unwinding'
during reverse operation.
8. Make sure your tools are stored/racked away from the
turning area of the lathe. Do not reach over a rotating
workpiece at any time.
9. Do not 'dig in' or try to take too large a cut.
10. Do not leave the lathe running unattended or leave
the machine until everything is stopped.
11. Some turning tools may have specific sharpening angles
that have been determined by the manufacturers; when
re-sharpening, adhere to these angles to maximise the finish
of your work.
Specification
508477
AT150PPL
Trade
375W 230V
400-3,600rpm
ER20 Collet
M24 x 1mm
1MT
250mm
150mm
12.5mm
699 x 315 x 270mm
22kg
Advertisement
Table of Contents
