Removing Freezer Shelves; Removing The Crisper, Meat Pan; And Covers; Changing Light Bulbs - Whirlpool EDI9CK Use & Care Manual

Removing Freezer Shelves...
l
Lift front slightly.
. Lrft back off supports
l
Replace in reverse order.
Lift
the Front
Then the Bock A
Removing the Crisper, Meat Pan
and Covers...
l
Slrde crrsper and meat pan strarght out to stop
l
Lift the front
l
Slrde the rest of the way out
0 ReDlace in reverse order
Push the lab
to Clear the Cover.
Snap Back into Place.
l
Covers are held In place by two pegs at the back
and two notched tabs In front
- Press front tabs out of the wcy
-Lift cover front
- Lift back off the pegs
- Replace in reverse order
Changing light Bulbs.. .
Before removing a light shield for cleaning or for
replacing a bulb.
unplug the retrlgerator. Use op-
phmce bulbs only
Pull Oft the Dial;
Pull Out at the Bottom
Ice Cube Trays...
lo remove Ice:
l
Hold tray at both ends
. Slrghllv twist
If cubes are no1 used, they may shrrnk. The movrng
cold air starts a slow evaporatron The longer cubes
are stored. the smaller they get
Optional Automatic Ice Maker...
L
On
daise Signal
Arm to Stop Ice Maker.
\
Lower Slgnal
Arm to Start It
If you have the automatic ice maker accessory or
plan to add one later [Part No. ECKMF-6). there are
a few things you will want to know.
l
The ON/OFF lever
IS
a wire signal arm.
Down...for making ice automatically,
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water runnrng when ice maker IS
working. You'll hear ice fall into the brn. Don't let
these sounds bother you.
l
The ice maker will not operate until the freezer
IS
cold enough to make ice. This can take overnight.
l
Because of new plumbing connections, the first
ice may be discolored or off-flavor&. Drscard the
first few batches of ice.
l
If ice is not berng made fast enough and more ice
is needed, turn the Temperature control to a hrgher
number Wart a day and, If necessary, turn the Air
Control to a higher number.
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes In the ice bin can also
become smaller by evaporation
Light bulbs behind retrlgeraior and freezer
control consoles:
- Pull control knob strarght off
- Pull bottom of control panel straight out.
-Lift top of panel off supports
- Replace with a 40.watt appliance bulb.
- Replace panel In reverse order.
5