Removing The Crispers And Crisper Cover; Adjusting The Crisper Humidity Control; Removing The Meat Drawer And Cover - Whirlpool ED25RQ Use And Care Manual

Pull out to the stop,
lif-l the front
d pull again.
Lift the cover
front, then
the back.
Pull out to the stop, lift the
front and pull again.
Removing the crispers and crisper cover
To remove the crispers:
1. Slide the crispcar straight out to the stop.
2. Lift the front.
3. Slide the rest 01 the way out.
4. Replace in reve'rse order.
To remove the cover:
1. Lift front of cover off supports.
2. Lift out cover b\, pulling up and out.
To replace the cover:
1. Fit back of COVE r in notch supports on walls
of refrigerator.
2. Lower into place.
NOTE: Glass cover will fit only above full width
crisper. Crisper(s) must be removed before
removing cover.
Adjusting the cl'isper humidity control
You can control thm? amount of humidity in the
moisture-sealed crisper.
1. The control car be adjusted to any setting
between LOW and HIGH.
2. LOW (open) lets moist air out of crisper for best
storage of fruits and vegetables with skins.
3. HIGH (closed) keeps moist air in the crisper for
best storage of fresh leafy vegetables.
Removing the meat drawer and cover
To remove the meat drawer:
1. Slide the meat drawer out to the stop.
2. Loft the front.
3. Slide the drawe* the rest of the way out.
4. Replace in reve-se order.
To remove the cover:
1. Remove meat crawer and crispers.
2. Lift front of cover off supports.
3. Lift out cover by pulling up and out
To replace the cover:
1. Fit back of cover In notch supports on walls
of refrigerator.
2. Lower into place
3. Replace meat drawer and crispers.