Graco E-Flo SP Instructions Manual page 13

2. Using the top mounting bracket (109), attach the
ram junction box (108) to the ram using two screws
(114) and washers (113) as shown in Figure 11.
Hex Nut
109
108
110
F . 11: Attach Ram Junction Box to the D60
IG
3. Attach the bottom mounting brackets (110, 111) with
four screws (115), nuts (116) and washers (113) as
shown in Figure 11.
Do not over-torque the ram junction box mounting
brackets. Over-torquing can damage the cylinder.
4. Disconnect the wires from the disconnect block (A).
5. Remove and discard the driver junction box cover
(C) and the disconnect switch (B) from the driver.
See Figure 12.
6. Remove and discard the extrusion (D), then remove
and discard the plug (E).
3A6931A
119
113,114
111
113,115,116
NOTICE
7. Remove the cord grip and save it for reuse.
E
Cord Grip
F . 12: Remove Driver Junction Box
IG
8. Install the electric driver (101) with the four screws
(132) and washers (133) included in the kit.
132,133
F . 13: Install D60 Electric Driver
IG
9. Install the cord grip that was removed in step 7 into
the driver junction box where the plug was removed.
See Figure 14 on page 14.
10. The power cable from the ram junction box (108) is
routed through the cable track. Run it through the
cord grip and connect it using the supplied
connectors. Connect the ground wire to one of the
two green ground terminals inside the driver
junction box.
Installation
D
A
B
C
101
13