Adjusting Meat Drawer Temperature; Adjusting The Refrigerator Shelves; Removing Crisper, Meat Drawer And Cover; Removing The Freezer Bin - Whirlpool ED22PM Use & Care Manual

Adjusting meat drawer temperature...
Cold air flows against the meat drawer through
USE CONTROL TO ADJUST
an opening between the freezer and the re-
t
MEAT DRAWER TEMPERATURES
frigerator. This helps keep the meat drawer colder
than the rest of the refrigerator.
a
Set the control to let more or less cold air through.
Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use
your refrigerator. Glass shelves are strong enough
to hold bottles, milk and other heavy food items.
GLASS SHELVES ARE
HEAVY. BE CAREFUL.
To remove glass shelves:
1.
Tilt up at front.
2. Lift up at back.
3. Pull shelf straight out.
To replace glass shelves:
1.
Guide the rear hooks into the slots in the shelf
supports.
2. Tilt up front of shelf until hooks drop into slot.
Lower front of shelf to level position.
Removing the crisper, meat drawer and cover...
To remove the crisper and meat drawer:
1.
Slide crisper and meat drawer straight out to
stop, lift drawer, then slide the rest of the way out.
2. Replace in reverse order.
To remove the covers:
1.
Push up crisper cover glass insert from bottom,
then slide out with both hands.
2. Lift front of cover frame.
3. Lift out cover frame by pulling up and out.
4. Repeat for meat drawer cover.
To replace the covers:
1.
Fit back of meat drawer cover in notch supports
on walls of refrigerator, then lower into place.
2. Repeat for crisper cover frame.
3. Slide back of crisper cover glass insert into
place, then lower front.
Removing freezer bin...
For proper air movement, keep the freezer bin in
place when the refrigerator is operating.
To remove the bin:
1.
Slide bin out to the stop.
2. Lift the front to clear the stop.
3. Slide out the rest of the way.
To replace the bin:
1.
Place bin on the slides.
2. Make sure the stops clear the front of the slides.
3. Slide bin in.
6
PULL OUT TO STOP,
LIFT THE FRONT 'y
AND PULL AGAIN.
1
GLASS INSERT,
LIFT THE FRAME FRONT,
THEN THE BACK.
,, GLASS IS HEAVY.
BE CAREFUL.