Table of Contents
Advertisement
Models LB480A/LB680A USB PowerSensor+™
Product Manual PPA (Pulse Profiling Application)
Pictured below is an example of all gates on and each taking a measurement: Peak Power, Pulse Width, PRF, Droop,
and Duty Cycle. Again, you activate a gate by clicking on it then setting its position as previously described. Finally,
you can switch between these two modes of operation (gates and markers) to position markers within gates and gates
within markers.
You can compare these manual measurements with an automatic measurement. Be sure that there are at least two
pulse cylces in the Measurement view. Now select the Auto Measure pane and click Start Measurement.
NOTE: You can always highlight the span if you drag the cursor over the Panorama view (or select a highlight span
percentage and start time) even if you are in markers or gates mode. To highlight in the Measurement view you must
be in the highlight mode. If you do not switch to highlight mode before clicking/dragging in the Measurement view you
may inadvertently reposition markers or gates.
Revision: 08/02/11
39
Advertisement
Table of Contents
