Table of Contents
Advertisement
Models LB480A/LB680A USB PowerSensor+™
Product Manual PPA (Pulse Profiling Application)
5. The Toolbar Functions
Display Control Toolbar (Pointer Control)
Results Pane
Zoom
Reset
Highlight (Mode)
Markers (Mode)
Gates (Mode)
The Pulse Profile Application is designed to be highly interactive using the mouse. The mouse pointer has three
modes of operation: Highlight, Markers and Gates . The Pointer Control (highlighted in yellow below) shows what
mode is active for cursor control. The default mode is Highlight. These controls are available from the Display
Control toolbar and in the Results pane for easy access. The screen below shows an arbitrary input to the sensor.
The mouse pointer is in Highlight mode and a section of the span on the Panoramic Trace has been highlighted.
This highlighted time seqment appears as the bottom Measurement Trace to allow for closer examination. Again, the
Display Control toolbar mimics the same controls in the Results pane so you can readily tell what mode is active.
Highlight is used in conjunction with Markers and Gates to take measurements. These measurements will then be
displayed in the Results pane. The Trace Measurements in the Results pane will always indicate the Peak, Pulse,
CrF (Crest Factor), Average (power in the pulse), and Duty Cycle. You can expand or collapse the individual headers
in the Results pane. Notice that there is a short discription of each toolbar function when you hover over it with the
cursor.
Revision: 08/02/11
18
Advertisement
Table of Contents
