Table of Contents
Advertisement
Models LB480A/LB680A USB PowerSensor+™
Product Manual PPA (Pulse Profiling Application)
2. Installing the Software and the Sensor
Initial Inspection
Check the shipment for any damage to the shipping container or the components inside.
Support Contact Information
LadyBug Technologies LLC
3317 Chanate Rd. Suite 2F
Santa Rosa, CA 95404
Phone 707.546.1050
Fax 707.237.6724
www.ladybug-tech.com
Operating System and Computer Requirements
The PowerSensor+™ line of products is compatible with Windows 2000 (SP2 or greater), Windows XP, and Windows
7 operating systems. Support is available for various test development environments including MS Visual Basic 6.0;
MS Visual Basic .NET; MS C# .NET; NI LabVIEW; NI LabWindows; and Agilent VEE.
Recommended PC configuration:
Pentium D
1G RAM
1.0 GHz Processor
CD Drive
USB 2.0 Port*
* The USB port or hub must supply 500 mA @ 5 V for each power sensor operation. Refer to the USB Considerations
section of this product manual to determine if your computer has a USB 2.0 port(s).
Installation Procedure
Install the Software
You will need the sensor with USB cable (supplied); a compatible computer with available USB 2.0 port; and the
software CDs (Qty 2). (Alternately, the application may be supplied on a USB flash drive).
Refer to the Quick Start Card (Windows XP or Windows 7) for the version 4.5 sw installation procedures.
Revision: 08/02/11
10
Advertisement
Table of Contents
