Table of Contents
Advertisement
Models LB480A/LB680A USB PowerSensor+™
Product Manual PPA (Pulse Profiling Application)
Markers Toolbar
Normal Markers
Markers are used to make measurements at a particular point (Normal Markers) or measure the difference between
two points (Delta Markers). Markers are only available in the Measurement view. The value of each marker is
displayed in the Results pane. The value of the active marker is displayed in the upper left portion of the Measurement
view unless it is turned off – see the Meas Notation On/Off button under the Display Options toolbar.
To manipulate (move or place) a particular marker the mouse pointer must be in the Markers mode. Because pointer
modes are changed quite often there are a number of ways to change modes as shown above. You can select the
Markers mode in four ways:
1. In the Results pane select the Markers mode icon.
2. In the Results pane click on any marker node. For instance, click the node labeled "Marker 1" to set the pointer
mode to Markers.
3. Under the Display Control toolbar select the Markers mode icon
4. Select the Markers toolbar and select any numbered marker button.
Revision: 08/02/11
25
Advertisement
Table of Contents
