Table of Contents
Advertisement
Ice cube trays.. .
To remove Ice:
l
Hold tray at both ends.
l
Slightly twist.
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation.
The longer cubes
are stored, the smaller they get.
Optional automatic ice maker.
On
8 Slgnal
to Stop Ice
lower Slgnal
Arm to Start It.
. .
1 Maker.
If you have the automatic
ice maker accessory
or
plan to add one later (Part No. ECKMF-oj), there are a
few things you will want to know:
l
The ON/OFF
lever is a wire signal arm.
Down. .for making
ice automatically;
Up...toshut
off the ice maker.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain
increased
storage capacity.
l
It is ncxmal for ice crescents to be attached
by a
corner. They will break apart easily.
l
You will hear water
running
when ice maker
is
working.
You'll hear ice fall into the bin. Don't let
these sounds bother You.
a The ice maker will not operate
until the freezer is
cold enough to make ice. This can take overnight.
l
Because
of new plumbing
connections,
the first
ice may be discolored
or off-flavored.
Discard the
frrst few batches
of ice.
l
If ice is not being made fast enough and more ice
is needed,
turn the Temperature
control to a higher
number. Wait a day and, if necessary. turn the Air
Control to a higher number.
l
If you remove
the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position
l
If cubes are stored too long, they may develop
an
off -flavor., like stale water. Throw them away. They
will be replaced.
Cubes
in the ice bin can also
become
smaller by evaporation.
l
The ice maker water supply
should not be soft-
ened
water. The chemicals
could damage
the ice
maker molds.
Changing light bulbs...
WARNING: Beiore removing
a light shield
for
cleaning
or for replaclng
ihe bulb,
unplug the refrlgerutor
or turn off lhe
electrlclty
leadlng
to the refrlg-
erator
at the maln power
supply.
Shock and InJury can occur If elec-
trlclty remains connected.
Pull Ott the Dial;
Pull Out at the Botto
Light bulbs behlnd refrigerator
and freezer con-
trol consoles:
1, Pull control knob straight off.
2. Pull bottom of control panel straight out.
3. Lift top of panel off supports.
4. Replace
with a 40-watt appliance
bulb.
5. Replace
panel in reverse order
Light bulb above crisper:
1. Pull top of the light shield away from the back wall
2. Lit? shield off base supports.
3. Replace
with a 40-watt appliance
bulb.
4. Replace
shield in reverse order
Removing the base grille...
l
Open the doors
l
Pull grille outwards as shown,
l
Do not remove Tech sheet
fastened behind grille.
To replace:
l
Line up grille support tabs with metal clips.
l
Push firmly to snap into place.
l
Close the doors.
Advertisement
Table of Contents
