System Pressure; System Start; Save&Exit With Enter - MAC3 HydroController HCW MT 1P User Manual

Maintenance Menu Parameters Hydrocontroller
Name
Lanuguage [Italiano,English]
Pressure Shock
SlowRestartNumb.
Max.Motor current [0.45, 10.000]
Leakages
Tot. ShortC. Done
RemoteON Enable
Sector1 Pressure
Sector2 Pressure
Sector3 Pressure
Sector4 Pressure

System Pressure

NoGardenRestPres
Rotation Sense
Software Release
ResetFactorsConf

System Start

Save & Exit with ENTER
To exiting this menu, during the usual visualization of the parameters, you need to arrive at
the last parameter till the display:
Save&Exit
with ENTER
Press the key ENTER and exit the menu; all the parameters are saved in permanent
memory.
User Guide HC - Copyright © 2008 MAC3. All right reserved.
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: mac3@mac3.it
Range
Language desired
[0, 1] It is set to 1 when it measured a pressure more than double of
the system pressure
[0, 100] Number of the slow restart for the autoclave, restart after dry
running protection (1 each 50 minutes)
Max value rms for phase current
[0, 100] Number of big leakages
[0, 1000] Counter for short circuits phase-phase and phase-ground.
Default value 40.
[ON,OFF] If ON, the inverter is in STANDBY and wait external command
to start
[1, 7.5] Available on in GardenMode = ON
[1, 7.5] Available on in GardenMode = ON
[1, 7.5] Available on in GardenMode = ON
[1, 7.5] Available on in GardenMode = ON
[1, 7.5] Desired Pressure for the System
[1, 7.5] Restart pressure of the Hydrocontroller, it works only in
GardenMode = OFF
[0, 1] It changes the rotation sense of electropump via software
(only with three-phase electro pumps)
It displays the model of Hydrocontroller and the software
version installed in the device.
[0, 1] Set = 1 set all parameters in factory configuration
[ON,OFF] Powers or Not the electropump
ENTER key: saved in permanent memory all' the parameters
Man 01 Disegno 6328
description
English
37