Table of Contents
Advertisement
Step 3.
Slide the drive into the drive bay until it snaps into position.
Figure 8. Sliding the drive into the drive bay
Step 4.
Close the drive tray handle to lock the drive in place.
Step 5.
Check the drive status LED to verify that the drive is operating correctly.
• If the yellow drive status LED is lit continuously, that drive is faulty and must be replaced.
• If the green drive activity LED is flashing, the drive is being accessed.
Step 6.
Continue to install the other hot-swap drives in the set until the drive bay is full.
Step 7.
Check that the new drives are detected by the storage block:
To check the storage drive configuration, use the following command:
# # l l s s b b l l k k
Following is an example output:
NAME
...
nvme7n1
└─sed7
└─md125
└─md124
└─vdo_data
└─vdo
├─CBS_POOL_data
│└─CBS_POOL
│ ├─SPECIAL_METADATA_STORE_71c510a8973349de9183b18f0acc4b3d 253:13 0 1G
│ └─SPECIAL_TEMPLATE_STORE_ef7543aa482e44f493c13db90b5796e8 253:14 0 43.3T 0
└─CBS_POOL_meta
└─CBS_POOL
├─SPECIAL_METADATA_STORE_71c510a8973349de9183b18f0acc4b3d 253:13 0 1G
└─SPECIAL_TEMPLATE_STORE_ef7543aa482e44f493c13db90b5796e8 253:14 0 43.3T 0
MAJ:MIN RM SIZE
RO TYPE MOUNTPOINT
259:7
0 740.4G 0
253:7
0 740.4G 0
9:125
0 4.3T
0
9:124
0 4.3T
0
253:9
0 4.3T
0
253:10 0 43.4T 0
253:8
0 43.3T 0
253:12 0 43.3T 0
0
253:11 0 16G
0
253:12 0 43.3T 0
0
.
Chapter 3
Storage block capacity upgrade
disk
crypt
raid5
raid0
dm
vdo
dm
dm
dm
dm
dm
dm
dm
dm
23
Advertisement
Table of Contents
