Install the compute enclosure
Procedures for installing ThinkAgile CP compute enclosure in a rack.
CAUTION:
Ensure that at least two people lift and install the enclosure together.
Figure 22. Front latches on slide rails
To install the ThinkAgile CP compute enclosure on the slide rails, do the following:
Step 1.
Pull the slide rails forward until the rails click into place.
Step 2.
Push up the front latches.
Step 3.
Pull the slide rails all the way out.
Attention: You can only install the compute block enclosure successfully when the slide rails are
fully extended.
Step 4.
Remove all compute nodes and the shuttle from the enclosure.
Step 5.
Carefully lift the enclosure.
Step 6.
Tilt and lower the enclosure; then, push the slide rails toward the enclosure and make sure the
farthest nailheads on each side go into the slots on the slide rails.
52
Lenovo ThinkAgile CP Storage Capacity Upgrade Guide