Toshiba PA912 Instruction Manual page 16

Chapter 1 Introducing the PA912 Module
PROFIBUS-DP
Important
・ Confirm the combination condition before use the PA912 module.(See the table below). Correct combination of
module-version is needed for PA912 to work.
[Combination versions between PA912 firmware and type1]
PA912
firmware version PA912 GSD version
V1.00 TSB_0C32.gsd
V2.01 TSB_0C32_V2.gsd
V2.10 TSB_0C32.gsd
TSB_0C32.gsd
V2.20 or later
TSB_0C32_V2.gsd
[Combination versions between PA912 firmware and type2]
PA912
firmware version PA912 GSD version
TSB_0C32.gsd
V2.20 or later
TSB_0C32_V2.gsd
4
6F8C1259
System configuration example
RP913
master station
PROFIBU
PROFIBUS-DP PROFIBUS-DP
Slave 1
Figure 1-1 System configuration example
nV-Tool
Version
V4.5.1
V4.6.0 or later Not Avail
V4.6.0 or later Not Avail
V4.8.3 or later Avail
nV-Tool
Version
V4.10.3 or l a ter Avail
TC-net I/O loop (electric)
TC-net I/O loop (optical)
RS-232C
HMS PROFIBUS
configurator tool
(Anybus NetTool-PB)
Slave 2
type1 single system type1 duplex system
Byte-swap
firmware version firmware version
mode
（PU811） （PU811）
Not Avail
V01.3A or later V01.41 or l a ter
Byte-swap type2 (duplex system)
mode firmware version（PU821）
V01.B0 or later
nV-Tool
PROFIBUS-DP
Slave n
TC-net I/O
loop
singl e loop
only
FN812 OIS service
firmware Version control version
V01.50 or l a ter V04.C7 or later
TC-net I/O
loop
singl e loop
only