Remote Control - Logitech Rally Implementation Manual

LOGITECH RALLY AND RALLY PLUS IMPLEMENTATION GUIDE
g. REMOTE CONTROL: The remote can be easily held in the hand or operated while sitting
on the table. Up to five (5) remote controls can be connected to one system allowing
easier access to controls in larger rooms. See the "pairing a remote control" section for
instructions on how to pair additional remote controls to Rally.
1. Bluetooth pairing
2. Call answer
1
3. Call end
1
4. Microphone mute
5. Zoom in/out
Setting the camera presets: For preset 1 and 2, pan, tilt and zoom the camera to the desired
location and press and hold one of the presets for about three (3) seconds. The LED on the
camera will flash when the preset is saved. Repeat for the other preset. For the home preset,
move the camera to the desired location and hold the home button for about ten (10) seconds.
Again, the LED on the camera will flash when the preset is saved. At the start of a meeting,
the camera will move to the home preset position. Camera presets are stored in Rally, not the
meeting room computer.
RightSight (available as a software/firmware update for Windows 10 - see
Logitech.com for additional availability) will automatically frame the participants in the
meeting. To override RightSight, manually pan, tilt or zoom the camera. To reenable
RightSight, press the home button.
1. Call answer and end buttons function in supported applications.
6. Volume up/down
7. Camera pan/tilt
8. Home/RightSight
9. Camera presets
p09