Pairing A Remote Control To Rally; Camera Settings Application - Logitech RALLY Setup Manual

PAIRING A REMOTE CONTROL
TO RALLY
RALLY and the remote control are paired
at the factory You can pair up to 5
remote controls to RALLY to make it easier
to control the system in larger rooms
Or, if you need to pair a remote to the
camera, such as when replacing a lost
remote, do the following:
1. Press and hold button on the back of
the camera until the LED flashes blue
2. Press and hold the Bluetooth button
on the remote for 10 seconds to place
it in pairing mode
3. Once the remote and camera are
paired the LED will stop flashing
4. If the pairing fails, the LEDs will keep
flashing Start from step 2 and repeat
5. Press and hold the pairing button on
the Display Hub until the LED flashes
white
6. Press and hold the Bluetooth button
on the remote for 10 seconds to place
it in pairing mode
7. Once the Display Hub and camera are
paired the LED will stop flashing
8. If the pairing fails, the LEDs will keep
flashing for 2 minutes then stop Start
from step 2 and repeat
8 English
CAMERA SETTINGS
APPLICATION
Use this program to control the camera
pan, tilt, zoom, focus, and image quality
(like brightness and contrast) from
your computer The software can be
downloaded from www logitech com/
support/Rally