Whirlpool SF378PEW Use And Care Manual page 32

PROBLEM
Burner fails to
light
Burner flames
are uneven
Burner flames
lift off ports, are
yellow, or are
noisy when
turned off
Burner makes
popping noise
when on
Control knob(s)
will not turn
Self-Cleaning
cycle will not
operate
POSSIBLE CAUSE
The power cord is not
plugged into a live circuit with
proper voltage.
A household fuse has blown
or a circuit breaker has
tripped.
Burner ports are clogged.
Burner ports are clogged.
Air/gas mixture is incorrect.
Burner is wet from washing.
You are not pushing in before
turning.
The Oven Selector and Oven
Temperature Control are not
set to CLEAN.
The range clock does not
show the correct time of day.
The Lock Lever is not in the
CLEAN position - all the way
to the right.
The Start Time Dial does not
show the correct time of day
or the knob is not all the way
out.
The Stop Time Dial is not set
ahead to the time you want
the Self-Cleaning cycle to
stop.
SOLUTION
Plug the power cord into a live circuit
with proper voltage. (See Installation
Instructions.)
Replace household fuse or reset circuit
breaker. In case of prolonged power
failure, manually light burners (see
page 10).
Clean with a straight pin (see page 27).
Clean with a straight pin (see page 27).
If this fails, call an authorized Whirlpool
service technician for service.
Contact an authorized Whirlpool
service technician to check air/gas
mixture.
Let dry.
Push control knob(s) in before turning
to a setting.
Set both the Oven Selector and Oven
Temperature Control to CLEAN.
Reset clock to show the correct time of
day. (See page 13.)
Move Lock Lever all the way to the
right.
Reset the Start Time Knob to show the
correct time of day. Pull knob out all
the way.
See Step 3 in "Setting the controls" on
page 23 for proper setting instructions.
32