Parata Mini Customer Manual page 30

7.3.f Fold the "wings" in so that they fit along the sides of the nozzle cover.
Step 7.3.f
7.3.g Hold the nozzle cover (containing the foam breather) by the rounded
end, with the top of the cover facing up.
7.3.h Slide the nozzle cover onto the nozzle so that the cutout on each side
of the cover aligns with the corresponding tab on each side of the
nozzle.
7.3.i Push the nozzle cover firmly against the nozzle so that both sides of
the cover snap into place over the tabs.
7.4 If the nozzle cover was originally secured with tape, apply tape.
Skip to step 7.5 if there was no tape on the nozzle cover.
•
7.4.a Cut a 1-inch length of 1/2-inch wide tape.
©2015 Parata Systems, LLC
120-0465 Rev 03
page 30 of 40
Customer Guide
HPAC Cell Cleaning
Parata Technical Assistance Center
1-888-PARATA1 (727-2821)