Sam Cook Masterchef Line Executive PSC-10 User Manual page 25

INSTALLING/UNINSTALLING
THE JUG AND JUG COVER
1. Put the jug ④ on the jug socket ⑱, so that
the thickening on the base fi ts into the cor-
responding place in the back of the socket,
and gently press the jug to the housing to
trigger the locking mechanism.
2. Make sure the jug cover ⑧ gasket is clean.
3. Put the cover ⑧ on the jug ④. Rotate the
cover clockwise unti l the protrusions in the
cover fi t into the corresponding places in
the jug . To remove the cover, rotate
fi g. 2
it anti -clockwise. Please note that the top
edge of the pitcher is fi nished with a fl ange
which in two places has slightly fl att ened
caps - they serve to ti ghten the lid to the
pitcher - the lid has two hooks which aft er
mounti ng the cover must be under the fl at.
Incorrect closing of the cover may cause mi-
nor leaks during the operati on of the device.
fi g. 2
4. Insert the measuring cup ⑨ into the corre-
sponding hole in the cover ⑧.
5. To remove the jug from the appliance hous-
ing press the jug release butt ons ③ and lift
the jug.
CAUTION! Always make sure the jug and the
cover have been properly installed before
starti ng the appliance. Do not use the appli-
ance if the jug is empty.
CAUTION! Wait unti l the cutt er blades stop
before removing the jug cover.
CAUTION! The jug, cover and measuring cup
can be hot. Wear kitchen mitt ens.
INSTALLING/UNINSTALLING THE
CUTTER GUARD (MIXING PADDLE)
1. Install the jug ④ and the cutt er assem-
bly ⑦ in the jug installati on socket ⑱.
2. Hold the cutt er guard (13) by its round end
and press it into the metal end of the cutt er
guard, so that the plasti c blades of the paddle
eff ecti vely cover the cutt er blades
fi g. 3
3. To remove the att achment, hold it by its
round end and take it off .
CAUTION! Take extra care when working
around the cutt er. Cutti ng risk.
CAUTION! Never use the cutt er guard (mixing
paddle) with mixing speeds higher than "5".
INSTALLING/UNINSTALLING
THE MIXING ATTACHMENT
(BUTTERFLY WHISK)
1. Install the jug ④ and the cutt er assem-
bly ⑦ in the jug installati on socket ⑱.
Hold the mixing att achment ⑭ by its
rounded end and press it into the metal
ending of the cutt er assembly
.
fi g. 3
fi g. 4
2. To remove the att achment, hold it by its
round end and take it off .
CAUTION! Take extra care when working
around the cutt er. Cutti ng risk!
CAUTION! Never use the mixing att achment
(butt erfl y whisk) with mixing speeds higher
than "4". Never insert the spatula through the
hole in the jug cover when using the mixing
.
fi g. 4
2 5