Maintenance - Westfalia GM 2500/45 TS Original Instructions Manual

the saw chain to stop before removing the machine.
▪
When cutting limbs under tension, always be alert for spring back.
There is risk of injury! Cut such limbs from the underside in order to
avoid jamming the chain saw.
▪
Always be alert when cutting young trees. Thin material can be
jammed in the saw chain.
▪
The chain saw is not designed for trimming bushes.
4. Cutting thick Branches
▪
When cutting off larger branches, you should first cut into the
branch from below. First cut into the branch from below outside the
place where you intend to cut off the branch. The cut should go
from one third to halfway through the branch. This prevents the
branch from buckling when you cut into the branch from the top
outside the first cut. Finally, cut off the stump with one clean cut.
First Cut

Maintenance

▪
Before cleaning and maintaining the chain saw, disconnect the plug
from power mains.
▪
The guide bar has to be replaced, if the guide groove is worn.
▪
Effective working with the chain saw is only possible if the saw
chain is in good condition and sharp. This also reduces the risk of
kickback.
▪
The saw chain can be sharpened in a specialist workshop. Do not
Operation
Second Cut
39
Third Cut