Step 1 - Connect the System
To connect the system in a Stand Alone configuration, you need the hardware
indicated in Figure 1. In this layout the data is transmitted to the Host on the
main serial interface. Data can also be transmitted on the RS232 auxiliary
interface irrespective of the main interface selection.
When One Shot or Phase Mode Operating mode is used, the reader is activated
by an External Trigger (photoelectric sensor) when the object enters its reading
zone.
PG6000
CAB-DSxx-S
Matrix 300N
Product Reference Guide
Rapid Configuration
I/O, Aux
Figure 1 - Matrix 300N in Stand Alone Layout
Chapter 1
CBX
Main Serial Interface (RS232 or RS422 Full-Duplex
External Trigger (for One Shot or Phase Mode)
Host
1