Footrests - Sunrise Medical SOPUR Xenon2 FF Directions For Use Manual

6.3 Footrests

Various footboards are available on the Xenon. These can
flipped up to make it easier to transfer to/from the chair. They
are described individually.
Lower leg length
By undoing the clamp screw (Fig.6.3.1), you can adjust the
lower leg length. Loosen the clamp screw, adjust the tube with
the footboard to the desired position.
Tighten clamp screws again (see the page on torque). Ensure
that the plastic push joint is located under the clamp screw in
the correct position.
WARNINGS!
• Do not stand on the footplate during transfer. The chair is likely
to tip to the front when standing on the footplate. Always place
your feet securely on the ground for transferring into or out of
the chair.
Platform Footrests
The footplates can be flipped up to make it easier to transfer to
and from the chair.
The footplates can also be tilted to six different angles relative
to a level surface.
Tighten screw (1) firmly on the outer side.
By removing the clips (2), the footrest can be adjusted to three
different positions toward both the front and rear. Loosen the
adjustment screw (3) to change the horizontal position of the
footboard.
For this purpose, the footboard must be flipped up,
(Fig.6.3.2 to Fig.6.3.4).
When finished, make sure that all screws have been properly
tightened (see the page on torque).
A minimum interval of 2.5 centimetres from the ground should
always be maintained.
XENON 2 FF
Fig.6.3.1
Fig.6.3.2
Fig.6.3.3
Fig.6.3.4
47 Rev.3.0