Saxby Lighting Max Instruction Manual

Safety instructions of batteries and chargers
Batteries
• Never attempt to open for any reason.
• Do not store in locations where the temperature may exceed 40 ºC.
• Charge only at ambient temperatures between 4 ºC and 40ºC.
• Charge only using the charger provided with the tool.
• Do not cause short circuits. If connection is made between the positive (+) and negative (-) terminal directly or via
accidental contact with metallic objects, the battery is short circuited and an intense current will flow causing heat
generation which may lead to casing rupture or fire.
• Do not heat. If batteries are heated to above 100 ºC, sealing and insulating separators and other polymer components may
be damaged resulting in electrolyte leakage and/or internal short circuiting leading to heat generation causing rupture or file.
Moreover do not dispose of the batteries in fire, explosion and/or intense burning may result.
• Under extreme conditions, battery leakage may occur. When you notice liquid on the battery, proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid skin contact.
- In case of skin or eye contact, follow the instructions below:
i. Immediately rinse with water. Neutralize with a mild acid such as lemon juice or vinegar.
ii. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do not incinerate the battery.
Chargers
• Use the charger provided with the tool only to charge the battery
• Have defective cords replaced immediately.
• Do not expose to water.
• Do not open the charger.
• Do not probe the charger.
• The charger is intended for indoor use only.
Care and Safety
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before cleaning.
Always make sure the light is off and complete cool down before clean it.
Do not attempt to replace or change the diode lights! If the protective glass is
cracked or broken, it must be replaced before the work light can be used again.
Replace Cracked Protective Glass
V1 14/11/2019
Saxby Lighting. BH17 7BY
fold line
Instruction manual
MAX
RECHARGEABLE FLOODLIGHT
81557
www.saxbylighting.com
148mm