Table of Contents
Advertisement
HARDWARE
IMAGE
Lag Bolt
Lag Washer
Concrete Anchor
Screw
Screw
Screw
Screw
Screw
Screw
Spacer
Spacer
Spacer
M4/M6 Washer
M8 Washer
X-Pattern Adapter Screw
X-Pattern Adapter Screw
INSTALLATION
Layout and Drilling
1.
Determine general location of the display.
2.
Use a stud finder to find the nearest wall stud if applicable and mark their location.
NOTE: Stud sizes must be a minimum of 2"x4" and covered with no more than 3/8" thick dry wall.
3.
Tape template flat and level to wall surface, aligning the template's slots with the stud markings on the wall.
NOTE: Template corners fold up to catch debris.
4.
Use a pen or pointed object to mark bore locations.
ATTENTION: Before drilling, verify there is a minimum of 1-3/8" of concrete thickness to be used for the concrete
anchors. Ensure to mount in a solid part of the block, generally 1" minimum from the side of the block.
Cinder block must meet ASTM C-90 specifications.
ATTENTION: Concrete must be 2500-3000 psi density minimum. Lighter density concrete may not hold concrete anchor.
ATTENTION: A standard electric drill on slow setting should be used to drill the holes instead of a hammer drill to avoid
breaking out the back of the hole when entering a void or cavity.
5.
Drill holes in marked locations:
• Use 3/32" bit for drilling into wooden studs.
• Use 5/16" bit for drilling into concrete wall.
ATTENTION: Be sure to drill holes centered within studs. Do not drill into mortar joints.
DESCRIPTION
ITEM
BAG 1
(A) 6.3 × 50 mm
(B) 6.4 × 18 × 2 mm
(C) 8 × 50 mm
(D) M4 × 20 mm
(E) M6 × 20 mm
(F) M6 × 40 mm
BAG 2
(G) M8 × 20 mm
(H) M8 × 40 mm
(I) M8 × 50 mm
(J) 8.5 × 15 × 5 mm
(K) 8.5 × 17.5 × 19 mm
BAG 3
(L) 8.5 × 17.5 × 22 mm
(M) 6.4 × 18.2 × 2 mm
(N) 8.4 × 20 × 2 mm
(O) M6 × 10 mm
(P) M8 × 10 mm
3
QUANTITY
4
4
4
4
4
4
4
4
4
4
4
4
8
8
4
4
Advertisement
Table of Contents
