Table of Contents
Advertisement
Wall Mounting of Arm Assembly
1.
If needed, hammer concrete anchors (C) into wall.
ATTENTION: If anchors are going to be applied to a plastered
concrete wall, the anchor must be recessed
beyond the plaster to reside fully in the concrete.
2.
Apply lag washers (B) to lag bolts (A).
3.
Hold Arm Assembly in place while applying lag bolts (A) with washers (B).
4.
Tighten bolts (A) snugly without overtightening.
CAUTION: Overtightening can damage the bolts and reduce their holding strength.
Mounting to a Concrete Wall
Assemble Display Bracket
Small Displays (Up to VESA 200x300)
The display bracket does not require assembly for this display size. Proceed to the mounting section for instructions
on how to mount the bracket to the display.
Large Displays (Up to VESA 400x400)
1.
Align the holes in the X-pattern brackets with the Adapter Plate and secure using four Bolts (O & P) (Figure 2).
2.
Attach the assembled Adapter Plate to the display using the screws (O & P).
Adapter Bars
Bolts (O)
Bolts (P)
Mounting to a Wood Stud Wall
Adapter Plate
Figure 2
4
Bolts (O)
Bolts (P)
Advertisement
Table of Contents
